Ultra Start 33xx Series Guia de Instalação

INSTALL GUIDEwww.ultrastarters.comTechnical Support: 866-698-5872 ext [email protected] All 32xx and 33xx SeriesAdvanced 2-Way Remote S

Step 1 - Connect All Of the Following WiresINSTALL MANUAL REMOTE VEHICLE STARTER PAGE 10M

REMOTE VEHICLE STARTER INSTALL MANUAL

IMPORTANT! The system must be Tach Learned before remote starting. The Auto Tach Learn is the same for the TL (tachless) series.1) Turn the ignition k

Tach Learning the remote starter is one of the most important steps in the installation process. Do not tach learn vehicle while the engine is in high

1) With the ignition in the OFF position, turn the ignition key from “Off” to “On” 3 times, ON-OFF-ON-OFF-ON within three seconds. NOTE: Leave

Menu 1 - Press 1 Flash 2 Flashes 3 Flashes1 Ignition Lock Enabled Lo

Setting 1 Ignition Auto Lock1) Enable 1 Flash/Honk Doors Lock/Unlock with Ignition key.2) Ignition Lock Only

Setting 1 Secure Valet Mode (time required to set the system into Service Mode)1) Secure Valet 1 Flash/Honk Hold the Program

Setting 1 Special Door Lock/Unlock Operations (Factory Alarm Rearm).1) Type 1 1 Flash/Honk Unlock before start. Lock pulse after s

Setting 4 Run Time1) 4 Minutes 1 Flash/Honk Runs for approx. 4 minutes when activated.2) 45 Minutes 2 Flashes/

Table of Contents Page 2Component/Feature List

Setting 1 Low Idle Learn- Same function as doing the Quick Tach Learn.This option is used for vehicles that maintain a High or Erratic idle after st

REMOTE VEHICLE STARTER INSTALL MANUAL

87868587a3087868587a30LockUnlockVehicleLock/UnlockSwitchTo Control Relay or ActuatorGreenFused +12VBlueGroundNegative Type Door Locks 250maNegative Do

87868587a3087868587a30BlueGreenLockUnlockVehicleLock/UnlockSwitchTo ActuatorFused +12VxxCutCut87868587a30GroundDIAGNOSTICS1387868587a3087868587a30Blue

If the remote starter does not activate when the start button is pressed the park lights will flash a diagnostic to indicate what shutdown input has b

Feature List- Control module - 6 pin Main harness- Antenna with built in - 14 pin auxiliary harness

Recommended Installation ProceduresRemote car starters and alarms should be professionally installed. Review the installation and owner manuals and ac

Recommended Installation ProceduresMounting The Control Module - Never mount the module in the engine compartment. Select a location under the dash t

Wiring Diagram1155332244661234567891011121314YELLOWYELLOWPURPLE**BLUE/WHITE***GREENRED/WHITEWHITEBLUEREDBROWNGREEN/WHITEREDORANGEGREEN**WHITE*WHITE/BL

ACTIVE RF ANTENNA**1 2 3NOTE: The jumpers control the output from the WHITE wire on the main 6- pin harness. This is an 30a

Wiring DescriptionsMAIN CONNECTOR (6pin) Pin Function Description1-YELLOW Starter Output -

Wiring Descriptions Pin Function Description9-GREEN/ Hood Pin(-) - Input to detect ground whe